Stubby 8 Holding Tolerances
Welding Tips and Tricks Podcast · Jody Collier, Jonathan Lewis, Roy Crumrine
Audio is streamed directly from the publisher (traffic.libsyn.com) as published in their RSS feed. Play Podcasts does not host this file. Rights-holders can request removal through the copyright & takedown page.
Show Notes
Thank you for listening to this weeks Stubby Episode of the Welding Tips and Tricks Podcast! This weeks Stubby is about holding Tolerances. If you lay beautiful welds and blow the dimensions you just made a nice looking piece of scrap. Roy tells us a little more about his process when it comes to holding tolerances. Enjoy
Thank you to CK Worldwide for sponsoring this Stubby Episode!
If your looking to a top quality torch be sure to check out all of CK Worldwide products. Do you have a specialty job coming up that a normal torch just wont work, CK Worldwide most likely will have the right solution for you. Be sure to head over to CKworldwide.com to see all their great products!
If you have a question for us to answer in a Stubby episode please send them to [email protected] and put Stubby in the subject line. Thank you!